3 watt surface-mounted fixtures OTG-KL with AutoTest, IP65

This fixture comes with a test button and an AutoTest function. The fixture performs a monthly function test of 2 minutes and a yearly duration test of 3 hours. Furthermore, you can test the fixture manually by using the test button. This fixture is also available without the AutoTest function.

This fixture comes with 4 legends with the following directions: left, right, up and down. The legends can easily be placed on the fixtures, depending on what direction is applicable and desirable in your specific situation. Please note: to walk straight ahead, you need to use the legend with the arrow going upwards. Before attaching the legend to the fixture, it is best to first use a mixture of soap and water on the surface of the fixture. You can then easily smooth out the air bubbles under the sticker when you stick the legend on the fixture.

Extra legends

It is possible to order a separate legend set, consisting of 8 legends. Click here if you wish to order this set.

Installation

The LED emergency light can be mounted above doors, windows and on walls. When consulting a specialist, you can decide how many emergency lighting points you need and how you can mount them.  Circles are marked on the back and the 4 sides of the fixture that you can pierce to create holes. After you have drilled a hole, you can connect the wiring to the terminal block that is attached to the circuit board. This is how you connect the fixture to the electricity network (230V). To make the hole water-resistant, you can mount a pg9 strain relief in the drilled hole through which the wiring will go. This way you protect the fixture against water damage and the strain relief also ensures that the cable cannot be disconnected from the terminal block.

Continuous or emergency lighting

The fixture consists of 16 LED lights. The fixture can be set to a continuous mode (permanent lighting), or an emergency mode (non-permanent or non-continuous emergency lighting). When the fixture is set to the continuous mode, the light will be on even when there is no power failure. When the fixture is set to the emergency mode, the light will turn on when the fixture is not receiving power from the mains and it will stay on for at least 3 hours. Three hours is usually sufficient for employees and visitors to leave the building and also falls within the legal standard.

CE approved

All our emergency light models are CE approved and comply with the standards and requirements that apply in Europe. The housing and diffuser are made of high-quality synthetic.